Alpha TechnologiesAlpha XP-EDH3 Transponder Field Installation InstructionsEffective: February 2009
Before eld installation, the transponder's MAC address should be loaded into the CMTS, and DOCSIS conguration le options should be set. Alpha
1. Switch Battery Breaker OFF prior to removing the Inverter Module for USM Card installation and conguration.A chipset upgrade may be required; cont
745-419-C3-001 Rev. A (02/2009)4The XM2 batteries are isolated from chassis ground by design. Any voltage potential difference between battery (-) an
Installation of the Vout and Iout sense harness requires powering down the power supply. Use an alternate source of power during this procedure.CAUTIO
745-419-C3-001 Rev. A (02/2009)6SPI123456782Input and Output Connections, Generic ModelsConnections between transponder, power supply and laptopLegend
Method 1: Status LEDsAfter the initial transponder power-up, network communication can be veried by the following behavior: Rx LED on Solid, occasion
PowerAlpha Technologies®Due to continuing product improvements, Alpha reserves the right to change specications without notice. Copyright © 2009 Alph
Commenti su questo manuale